The process of installing Electric Water Heater

Posted by Rendy Harper on December 23rd, 2020

At first, when you install a water heater there are certain things to check like whether you install it the first time or just you work on maintenance. Not getting hot water may be due to certain issues in the heating process or due to no maintenance. So, it will be beneficial f you consult Sonoma county heating and air, Sonoma county plumbing before thinking of a replacement. If there are some top units in your water heater it means you get a new one. Even due to an increase in the number of family members purchasing bigger water heaters best option. So, before you get the water heater it is good to check all the below-mentioned points before getting the replacement of the old water heater.

The pressure of water: It is good to know what pressure your water heater holds. You can use a water gauge to check its pressure on the outdoor spot. Check the pressure and note whether it is more or lower than 80PSI. More pressure is not good so just call the service provider to shut- it off. If the valve available in your house is not capable to reduce pressure, then ask for water heater repair to get it done. It is necessary to check the water pressure of your house for all the water-using appliances. Lower-level pressure will cause drainage to clog the pipes. So, it is necessary to check the pressure to prevent yourself from the future inconvenience.

Expansion Tank: The next thing to check before installing Sonoma county heating and air, Sonoma county plumbing is an expansion of your tank at home. The main use of the thermal expansion of the tank is to improve the level of pressure of closed pipes. Measure the pressure of the water heater and never forget that the expansion tank is good to have because it is a basic requirement of the expansion tank. Before you purchase the new one check what the manufacturer recommends. For cleaning the pipe apply soldering paste on your own. After soldering heart, it to prevent it from removing. Whatever the pressure it holds must match with the water heater pressure for proper functioning. In case it does not match then ask the water heater installer to use hand air for increasing pressure. The electricity should be shut off to prevent circuit breaking. You can even use a tester to check whether the circuit is off or not and use tape to close the wire connections. So, these are all the important things you should check before installing the new electric water heater in your house.

Rendy Harper Is an author of this article. To know more about sonoma county heating and air and sonoma county plumbing so please visit our website.