Final step in the installation of stamped concrete sealer by fabcrete

Posted by brushmonster008 on March 16th, 2015

The last step in the installation of stamped concrete is to utilize a sealer suitable regarding exterior exposure conditions. Sealers offer several important benefits:

They will block the penetration regarding stains, oil, deicing chemicals as well as other contaminants.
They protect rubber-stamped concrete surfaces from damaging the teeth and wear.
The make stamped concrete better to clean and maintain.
They enrich along with intensity of stamped concrete floor, whether the color is integral or given by a dry-shake hardener and also antiquing release.
They add sheen for the surface, ranging from satin to high gloss.

How to choose the proper stamped concrete sealer
Before buying any sealer, check with the manufacturer to be sure the product is befitting your particular project. Below are a few important questions to question:

What conditions will the sealer be exposed to?
Is the sealer breathable?
What exactly is the drying time?
What exactly is the coverage rate?
What type of end and surface appearance do you wish to achieve?
What is living expectancy of the sealer, and does producer provide a warranty?
How easy could be the sealer to apply?
See more faqs here.

How to use stained concrete floors cost to stamped before implementing sealer to stamped concrete floor, the surface must become clean and dry to make certain good adhesion. Also, you ought to allow the concrete to be able to cure sufficiently -- generally weeks after placement, depending on climate. With stamped concrete, it’s especially important to be sure the surface is without any moisture in low spots with the stamp pattern, where h2o may accumulate.

There are several tools you need to use to apply sealer to be able to stamped concrete, depending around the product you’re using. Pump-up or perhaps low-pressure sprayers are finest for applying one-part, solvent-based sealers using a solids content below 35%. Airless, or perhaps low-pressure high-volume (LPHV) sprayers, can handle both water- and solvent-based sealers and enable very controlled application costs, allowing large areas being sealed in the quickest time. You can also use water- or solvent-based sealers using a paint-type roller. To work the sealer in to the textured surface and stamps pattern depressions, be sure to employ a roller with a relatively thick nap (about 3/8 inch). One of the better application techniques when securing stamped or textured surfaces is always to combine spraying followed back rolling to help keep the sealer for stamped concrete from negotiating in low spots also to help distribute the sealer consistently.

Learn more about determing the best applicator for concrete sealer.

Rubber-stamped concrete sealer dos and also don’ts

DON’T apply the particular sealer too thickly, or it will merely lie or puddle on top rather than penetrate. Acrylic sealers are created to go down very thinly, at thicknesses of only 1 or 2 mils.
DO apply sealer inside two thin coats as opposed to one thick heavy coat to accomplish more uniform coverage.
DON’T apply a solvent-based sealer more than a water-based product because the particular solvent can eat or soften the prevailing water-based sealer.
DO reference the sealer manufacturer's program guidelines for specifics about surface preparation, recommended program tools, and dry instances between coats.

When you are thinking of buying your concrete countertop sealer can recommend http://www.fabcrete.com/concseal.html for thousands and good advice.