What are the commonly used universal joint shaft alignment measurement methods?

Posted by shaftndrive on March 17th, 2021

If it is found that there is an analysis deviation of the universal joint shaft, it must be found in time to complete the centering work.

Measure with center card and feeler gauge. It can measure the radial clearance and axial clearance of the cardan shaft at the same time, with simple operation and high measurement accuracy. Use a square and feeler gauge to measure the radial deviation on the outer circle of the universal joint shaft. We can use the feeler gauge to measure the axial gap deviation between the two halves of the coupling.

So what are the methods when we are measuring China CV Axle Suppliers cardan shafts? What are the commonly used universal joint shaft alignment measurement methods? Use the clamp to install the reference half coupling and use the dial indicator to measure the gap and the deviation of the axial gap and then adjust accordingly, and this method can improve the measurement accuracy. Dial indicator measurement method. Everyone is making corresponding measures.

Can achieve the purpose of alignment. We can carry out the measurement according to the above methods. Do not forget to follow the correct method to ensure the smooth operation of the process.Generally speaking, certain measurement and calculation work is required before the universal joint shaft is aligned. I believe it will be very helpful for everyone's alignment work.

The above is the introduction of several common universal joint shaft alignment measurement methods.. Since the center card does not have a unified specification, we need to make the corresponding production ourselves