Electrical Solutions: 3 Reasons My Lights Don't WorkPosted by Weinreich Delgado on April 24th, 2021 A few days ago an excellent friend called. browse around this site explained in my experience that this flood light in the front of his house wasn't working. He informed me he changed the bulb. We scheduled a time for the service call. Upon arrival I removed the switch plate. take a look at the site here tested the circuit for voltage. My voltage meter showed 122.5 volts. I returned to my truck. After retrieving a single-pole almond switch, I removed the existing switch. After installing the new switch, I recognized that the light still didn't work. I retrieved a ladder in the truck. I found a lamp inside the den and removed a practical bulb. After installing the significant bulb, the fixture produced light. Sometimes customers call saying they require a breaker. I have to ask, "How did you know?" Through further discussion both of us realize the specific situation will demand more investigation. One customers 3 way switch problem stemmed from a very different light. The daisy chain fashion of wiring had eliminated the power source. We got several other devices before he revealed another light that had quit working. The neutral was no longer coupled to the circuit. I wrote down this list of guidelines to help you the beginner troubleshooter. 3 Reasons My Lights Aren't Working: My bulb is burned out. The switch is not working. There isn't voltage present at the light. I have been troubleshooting residential lighting circuit's for decades. There isn't any fool-proof method for your process. You can eliminate some headaches using these steps. Test your replacement bulb before installation. I have placed another bad bulb into a fixture. This causes confusion. electrician redland bay can next remove the switch plate. Test for voltage at the switch. The voltage can be transferred through a solid insulated wire. If voltage is present, take away the insulation form both ends of the jumper wire. You can touch both sides on the screws simultaneously. If the switch is defective, the light should produce rays of light. After replacing the switch, the sunshine work. If this fails, you must take away the permanent fixture. Once the fixture is removed, test for voltage. You will need to turn the switch on. This will complete the circuit. I have had not many examples that method didn't solve. It is easy to get confused if there isn't any real plan of action. Troubleshooting isn't impossible. It might be challenging.Like it? Share it! More by this author |