How to PowderCoatPosted by Mygind Noonan on May 17th, 2021 Steps 1 Determine the type of material you are going to powdercoat and after that go with a suitable powder for the finish. Powdercoating is completed with thermoplastic or thermoset polymer powder, and the materials are formulated for bonding with assorted base metals to give the best results. 1 X Research source See the following section for any detailed discussion from the differences between thermoset and thermoplastic coats. What's good for the car will not be good for the small trinket or decoration. 2 Disassemble all threaded or lubricated interfaces before beginning, including whatever you wouldn't like coated. It sounds simple, but some people forget this. The powder coat applying will stick to everything (if properly done) in your rig, making sealed surfaces, bearings, clamps, bolts and nuts, etc. useless after blasting. 2 X Research source 3 Clean the beds base metal thoroughly. 3 X Research source Using bead or abrasive blasting on hard metal, including cast iron or steel, will remove mill and rust scale, dirt and foreign materials. Chemical solvent cleaning will remove any grease, oil, or paint, and light-weight sanding can be achieved in order to complete preparing the top. Aluminum, magnesium, as well as other soft alloy metals could be solvent cleaned and wire brushed, or sanded as needed. For example, you could sand-blast anything you want to powder coat until it's as a result of bare metal. official statement is the starting point along the way. If you don't have access to a sandblaster, it's also possible to use a wire wheel, bench-grinder, or perhaps sandpaper. Just as long as you obtain the information down to bare metal. The alternative is always to strip the metal from a remaining grime or gunk. You can do this by soaking them in acetone (if them is small enough) or by wiping it by having an acetone-soaked rag. 4 Apply the powder for the object to be powder coated. This is done by using a "gun" or compressed air sprayer which electrostatically charges the powder material then it sticks on the grounded base metal object receiving the coating. 4 X Research source These guns can be obtained from various suppliers, and cost as low as 0. For experimental purposes, you are able to apply the powder to a flat metal surface by dusting it entirely on, and spreading it with a thin, even layer. Make sure you might have your electrostatic charge hooked up to whatever part you might be coating. The powder you utilize won't properly adhere unless it's given electric power charge to keep onto. After applying the coat to start with curing, try not to brush or blow on the powder coat, as this will result in a number of the powder to disappear, so you have a less precise coat. 5 Cure the metal at a temperature appropriate for your powder material you have. A conventional oven is acceptable for this specific purpose if the metal is small enough to adjust to, otherwise, an infrared heat lamp or other flame less heat source must be used. Normally, the object is heated to 350° to 375° F (175° to 190° C) approximately 10 to 15 minutes, and able to cool. 5 X Research source You can use a conventional oven to powder coat smaller items. Just be sure that you won't be using the oven in order to smoke food following the powder coating. Once you've used an oven to powder coat, it absolutely shouldn't be used for cooking.Like it? Share it! More by this author
|