7 Things You Should Not Do With micro screw

Posted by Jiles on May 23rd, 2021

But you have to worry about permanent damages that might happen to the pipe and to the motor. Before that happens, you should thaw out your washer first. Here are some of the steps you have to follow:

1. Go to the main valve of your water supplier and turn off the valve. After doing this step, go to the sink closest to your washer. Direct the pipe of your washer to the sink so it will drain out thawed ice.

2. Get an empty bucket and place the end of the pipe there. You might also want to get extra towels to catch water that might ooze out from the pipe once it has already thawed completely. You should start from the pipe in the faucet sink and progress to the frozen area to avoid sudden rush of water.

3. Get a small propane torch. This is the same one you use in lighting your charcoal grill or when you are toasting cheese on top of your home-made soup. micro screw supplier Wear gloves and goggles for extra protection. Hold the pipe 9 inches away from the torch. Ignite the torch and run it back and forth until it has started to thaw out. Do not directly heat up the pipe or you might inadvertently damage it.

4. After doing this, get a hair dryer and crank it up to the highest heat setting. Just like the propane torch, also move it back and forth. This will thaw out the pipe but will not directly expose it to flame.

5. Another remedy you can try is a heat lamp. This is used as a heat source during winter season, especially when you are camping. You can place it 8 inches away from the pipe. You can use this if the pipe of your washer is installed behind walls or if you cannot gain access to the pipe easily.

6. For pipes that are exposed to you, just use a hot water heating pad. Wrap it around the pipe and let it stay there until it has returned to its normal state.

You might want to winterize your washer next time to avoid this from happening. Make sure you maintain your washer well all the time to prolong its life.

Soaps and detergents often build up in the soap dispenser drawer of the washing machine, causing a crusty build-up which may block the easy flow of water, and you may find yourself confronted by a torrent of water spilling out from the machine. Should you find yourself in this unhappy situation, there are a few tips to solve the problem.

Should you find your machine leaking immediately switch the appliance off at the wall plug or at the mains, stopping the water flow. Clean the soap dispenser drawer with a moist cloth and an environmentally-friendly and economical product such as baking soda or vinegar.

Should this not control the leak, switch off again and check that all drainage pipes are in the proper position. These are fairly easily dislodged and can easily be repositioned. Also check that there is nothing blocking the drain into which the waste water flows as this can also cause the machine to flood. Washing soda will be useful here as it effectively breaks down the sludge which is blocking the drain, although it sometimes takes a little time to take effect.

Should this course of action not control the leak, it is time to call in a specialist. Under no circumstances should an unqualified person undertake complicated electrical repairs - leave it to the experts.

Simple maintenance, however, can avoid many of these nuisances. Keep the soap drawer and housing clean at all times and do not allow old soap and dirt to build up. Carefully follow the manufacturers' instructions and use only the correct amount of soap. Using excess soap is a waste of money and can cause build up and obstructions, so be sure to follow directions to the letter. Do not place soap tablets in the dispenser drawer - they are designed to go straight into the wash as instructed. Tablets in the soap drawer may not dissolve properly and lead to problems by blocking the pipes. If you are using a reliable brand of washing powder and are dutifully following the instructions the soap drawer should be empty at the end of the cycle. If you find that soap is left in the drawer after a wash cycle, try cutting down on the powder used.

Remember that all washing machines, as with other household appliances need to be regularly serviced and maintained. Keep your washing machine in good working order and look forward to trouble-free use for many years.