How to Replace Your Whirlpool Coupler 285753A

Posted by shahinc on March 2nd, 2023

The Whirlpool Coupler 285753A is an essential part of your washing machine that connects the motor to the transmission. Over time, it can wear out or break due to constant use, and replacing it can be a cost-effective way to extend the lifespan of your washing machine. In this blog, we'll guide you through the steps on how to replace your Whirlpool Coupler 285753A.

What You Will Need

Before starting the replacement process, make sure you have the following tools and materials:

A new Whirlpool Coupler 285753A
A socket wrench with a 1/2-inch socket
A Phillips head screwdriver
A flathead screwdriver
A towel or rag
Safety glasses

Step 1: Turn off the Power

Before starting any work on your washing machine, turn off the power supply. Unplug the machine from the electrical outlet, or turn off the circuit breaker that controls the power to the machine.

Step 2: Remove the Cabinet

To access the coupler, you'll need to remove the washing machine's cabinet. Start by removing the two screws that hold the control panel in place. Tilt the control panel forward and disconnect the wiring harness that connects it to the washing machine.

Next, use a flathead screwdriver to remove the two brass clips that secure the cabinet to the back panel. Once the clips are removed, lift the cabinet off the base of the machine and set it aside.

Step 3: Remove the Pump

The pump is located at the front of the machine and will need to be removed to access the coupler. Use a flathead screwdriver to release the clips that hold the pump in place, and then detach the pump from the motor shaft.

Step 4: Remove the Motor

The motor is secured to the base of the machine with two metal clips. Use a Phillips head screwdriver to remove the screws that hold the clips in place. Once the clips are removed, carefully tilt the motor forward and disconnect the wiring harness.

Step 5: Replace the Coupler

With the motor removed, you can access the coupler. Use a socket wrench with a 1/2-inch socket to remove the bolts that hold the old coupler in place. Clean the motor and transmission shafts with a towel or rag.

Install the new coupler onto the motor shaft, aligning the prongs with the holes in the coupler. Then, align the coupler with the transmission shaft and secure it with the bolts.

Step 6: Reassemble the Washing Machine

Reattach the motor to the base of the machine and secure it with the metal clips. Then, reattach the pump to the motor shaft and secure it with the clips.

Replace the cabinet by aligning the back panel with the base of the machine and securing it with the brass clips. Reconnect the wiring harness to the control panel and secure the panel in place with the screws.

Step 7: Test the Washing Machine

Finally, turn the power supply back on and run a test cycle on your washing machine to ensure that it's working properly.

In conclusion, replacing your Whirlpool Coupler 285753A may seem like a daunting task, but with the right tools and a little patience, it's a DIY job that can save you time and money in the long run. If you're not comfortable with DIY repairs or have any doubts, consult a qualified technician for assistance.