Wood Burning Stoves - Flue Options

Posted by Flue Direct Limited on October 5th, 2016

A wood burning stove needs to have a flue pipe for directing the smoke  in the chimney giving it a direct escape outside the building. The stove pipe cannot be fed through the ceiling or the wall directly, it is mandatory to attach it with a flue. Flues, in this case, need to be constructed in sync with wood burner, any other kind of chimney lining will not help.

If your building is fitted with any other kind of chimney, it needs to be attached with the chimney. By using a suitable flue you can easily escape the undesired requirement of tar deposits that sometimes get collected in the chimney. These will stop the gases  from escaping and will heat up the chimney pipe. Therefore, a suitable material flue is a must for wood burners. Here are a few options you can ponder on:

Single Skin Flues

A solitary skin pipe channel is normally used to associate the stove funnel to the smokestack since it can permit some warmth once more into the room and is generally preferred in appearance over twofold skin protected pipe. Be that as it may, it must not stretch out into the smokestack inside in light of the fact that it will permit the getting away gasses to cool, which will build the danger of tar stores inside the fireplace.

Twin Wall Skin Insulated Flue

A twofold skin protected vent can be utilized with a wood blazing stove with no requirement for a stack as it can securely go through dividers and rooftops. This sort of pipe will guarantee that any getting away gasses stay hot, which will keep the flame risks connected with tar stores. It is conceivable to utilize just twofold skin pipe funneling, yet in the event that it is to be joined to single skin pipe channeling it is best to know that there is a distinction in measurement. Accordingly, it is best to do this exclusive in a territory where the change of channeling won't be unmistakable, for instance, near the roof.

Suggested Sizes

There are particular controls identifying with pipe sizes and the route in which they are fitted. The measurement of the vent must be bigger than the stove outlet or stove funnel. The proposal for the width of pipes is no less than 150mm for wood smoldering stoves as per Government rules.

There are similar rules identifying with the separation of the pipe outlet from the top of a building. This is on the grounds that the gasses must have the capacity to escape with the goal that they don't bring about a flame danger. These separations rely on upon the pitch of the rooftop and where the pipe end is in connection to the edge of the rooftop. Additionally, the pipe outlet ought not be too close to rooftop windows or neighboring structures.