The paper tray is stuck in the machine and difficult to remove

Posted by naira on February 4th, 2019

If the paper receptacle is stuck or tough to get rid of, don't force it. this may occur if the receptacle was inserted incorrectly. It should ride on the little plastic rails on the facet edges of the paper receptacle and should be inserted straight and parallel and not crooked. Perform the subsequent steps to get rid of the tray:

1. Push the receptacle into the machine as so much because it can go

2. If the receptacle is in as so much because it can go, pull the receptacle bent see if it will be removed

3. If you push the receptacle in and out a number of times, the receptacle can slide out.

4. Once the receptacle is out, apply either unguent or candle wax or a bit mineral jelly to the little plastic rail on the left facet fringe of the paper receptacle as shown below. It ought to be applied within the space shown in red that is concerning the rear three or four inches of the rail.

5. put in the paper receptacle being bound to insert it straight and parallel and not crooked. The machine should be lying on a flat level surface with no objects below the machine.

6. Pull the receptacle in and out a number of times to equally distribute the lip balm/wax/jelly employed in step four.

If the matter continues and your machine is at intervals pledge, you'll be able to find a Brother approved Service Center (ASC) in your space by clicking on the link below:or contact Brother client Service by line of work1-844-305-6556  brother printer support weekday through weekday, excluding holidays.If your machine is out of pledge, you'll be able to find a Brother approved Service Center exploitation the knowledge listed on top of.