Where And How To Apply VeneersPosted by Natural veneers on July 31st, 2019 In woodworking, Veneer refers to thin slices of wood, usually thinner than 3 mm (1/8 inch), that typically are glued onto core panels (typically, wood, particle board or medium-density fiberboard) to produce flat panels such as doors, tops, and panels for cabinets, parquet floors and parts of furniture. Also, being wood based product are mainly applied on Decorative interior and furniture applications for residential, commercial and hospitality sites. How:Veneer panels and Veneer edge bandings are currently being used by mechanized factories for furniture manufacturing with help of sophisticated machines like Panel saw, Multi boring and Edge banders. Veneer panels are also used extensively on site by carpenters and contractors, Veneer applications is done with help of standard P V A glue with or without nailing process. Applying wood veneer was once rumored to be a difficult task, reserved mainly for seasoned professionals. These days, since tools and supplies are readily available and many of the methods are so simple, even a novice woodworker can easily master the process. There are as many techniques for application as there are varieties of veneer, but contact cement is commonly regarded as the most practical method. It is also among the most enduring applications. Here are some guidelines to get you started as you learn how to apply the wood veneer. StepsApply Veneers:Step 1Cut the substrate (the material that the veneer is actually applied to) to the exact finish size. This way, you can cut just the excess veneer with a razor knife and avoid damaging the finished product by using a table saw. Step 2Select the most appealing section of the veneer pattern, which will be visible in the finished piece, keeping in mind that any excess will be trimmed. Step 3Place your template over the desired section of veneer and cut out that portion. Leave approximately one-half inch, or 1.27 centimeters (0.5 in), of excess on each side. Step 4Center the selected pattern section over the substrate panel and apply the contact cement. Following the manufacturer’s instructions, apply both the veneer and the substrate. Allow it to set. Step 5Use extreme caution when positioning the two elements for adherence. Since contact cement is so slip-resistant, they must be perfectly aligned on the first try Step 6Using mix & match veneers smooth by starting in the center and working out toward the edges using a veneer roller. Step 7Still using maximum pressure, smooth the surface with a smoothing blade to verify that the veneer completely adheres. Like it? Share it!More by this author |