How to Repair Water Damaged Phone

Posted by sakshi on December 16th, 2019

Most of us have faced the situation of losing their expensive mobile handsets in water. Water spilling could be dropped in a bucket full of water, wet in rains, coffee or tea spill. The data inside your phone could be very important. There are many techniques with the professionals who know how to revive the liquid damaged phone this is the basic manual they must have studied in a mobile repairing institute in Laxmi Nagar.

Steps to deal with wet mobile phones are:-

1)      Remove the battery/sim instantly - As soon as your smartphone gets wet, detach the battery or sim instantly. As early as you remove the battery this will help in saving the battery life. If water stays for more than 20-30 seconds it can get short circuit or there are fewer chances of getting it repaired. Remove the SIM card also because in today's time most phones don't have a battery opening area. Though water is a good conductor of electricity. So if water enters the motherboard it can cause high damage to the mobile phone and you can lose all the data that is important to you. In mobile phones where the battery can't be removed by opening the back cover, it will take a lot of time to recover the damage. Being a mobile repairing course in Laxmi nagar delhi professional it is a good decision to turn off the phone as soon as possible and side by side hold screwdriver and try opening the phone and detach the battery instantly. Because if there will be no power then there are fewer chances of getting a short circuit

2)      Open the device and dry out the water - Once you are done with detaching the battery or dismantling the phone, the first job is to dry all the liquid inside the phone. You can use different techniques as hairdryer, fan, heater, ac or direct sunlight, rice method, etc. If you are eager to learn a mobile repairing course, you can join the mobile repairing institute in delhi and make a successful career in this field. Whenever you are using any drying technique make sure all the water inside the device is cleaned up and dried. Make sure that charging port, head jack, sim slot all of these gets fully dried and there is no water clogged left. Blow direct warm air on the sides of the motherboard because it is the most important part of your device as it holds your data.

3)      Clean the motherboard - As water has minerals it can cause corrosion to the motherboard. If you have taken training from a mobile repairing course in delhi you should have better knowledge than to clean water from motherboard you can use thinner to clean that.

Like it? Share it!


sakshi

About the Author

sakshi
Joined: July 16th, 2019
Articles Posted: 30

More by this author