The Fundamentals Of Cork Floating Floor Installation
Posted by articlelink01 on February 12th, 2015
Cork tile flooring plays well when you want to maintain some temperature regulation for your house while being notably easier to install when compared to traditional wood. Now new engineered panels are available and can snap together without much necessity for nails or glue. This flooring system can rest well over concrete plywood or any other type of existing flooring. Knowing the steps of installing cork tile flooring can be of much importance when need comes knocking. What then are the basic steps that should be considered when embarking on cork floating floor installation?
Preparation is an important step when it comes to cork floating floor Installation is just as it is important in any other kind of flooring. Identifying vertical trims that can be cut to permit your new flooring to comfortably slide in. For this process a cork plank is placed at the top of a saddle at the door ways then butted to door stops. Trimming of the stops is then done by a flush-cutting backsaw then the sides above the saddle are joined together. It’s also important that casings at the door wall are cut and a cork plank is used to determine the much that should be cut. The saddle must be carefully pried up before installation of the flooring.in the case of a concrete floor, the base board should be removed to allow covering of the slab by Polythene sheeting which should run three inches up the wall.
The next procedure involves planks being laid on the longest and uninterrupted wall. The distance between this walls are measured and a one inch expansion allowance is subtracted. The remainder is the divided with a cork plank width to determine the course number that will be required to completely cover the floor. In the event that the last course falls short of half of a plank then the last and first courses will be cut narrower to allow the layout to be balanced. The full plank width is added to the last course’s width and the measure halved to calculate the last and first course’s width. A jig saw is then used to ensure the planks of the first course measure this value.
At this point you are ready to start the installation of the first course. Piecing together this course will involve lifting one plank from the floor to some inclination then sliding its end into that of another plank the ensuring the groove and the tongue cling together by gently pressing down. The process continues in a similar manner until completion of the first course with planks being joined by their ends. The last piece’s length can be cut if such need arises and a jigsaw should be used to cut with a clamped straight edge’s guidance.
Completion of this stage opens up the next step of inserting spacers on the wall. 0.5 Inch spacers are placed on the starting wall then the first course is slid in. the grooves side should face you and ensure that it’s tight and firm against spacers.
At this point you are ready for insertion of the remaining field. If the leftover piece when the first course’s last plank is cut measures above 10 inches, it can be used as the starter piece for the second course. The planks cut end is set on the end of the wall and against the spacer and its tongue pushed on the first course. The plank will then have a tapping block placed against it and a hammer used to coax the groove and tongue until they click together. The process continues until the field is filled up.
Installation of the last course follows a similar procedure with the expansion allowance considered. The floor is then trimmed out to give the cork tile flooring a finished look to enhance elegance. If you need the best look, then use cork floating floor Installation service.
