Step by step instructions show DIYers tips on how to obtain great results by fab
Posted by fabcrete001 on February 28th, 2015
Applying acid stain to your concrete floor can add dramatic marbling and provides a depth of color unavailable in any other sort of floor. These step-by-step instructions show DIYers tips on how to obtain great results.
Step 1: Remove the Trim Operate
If acid staining a new pre-existing concrete floor, remove all baseboards and trim work that could be damaged by the discolor mixture.
Step 2: Face mask the Walls
Cover your walls using 12-inch masking paper, to protect your walls from discoloration in the acid staining process (Image 1). Cover the many walls and exposed decrease cabinets. To attach the masking paper on the wall, wrap the painter's video tape around your finger to ensure both sides have adhesive with them. Tack a piece for the wall every 4 to 6 inches. Pull the paper tightly through the wall, and secure the paper in the top every 12 inches with another part of painter's tape. Remove your knobs on bottom pantry shelves and cover the material screws with painter's video tape.
Step 3: Mix your Acid Stain
Mix the acid discolor mixture outdoors or in a very place with good fresh air. Hydrochloric acid is the principle ingredient in the soiling mixture, so wear all protective gear recommended with the manufacturer. When mixing your acid stain, always add the acid stain on the water rather than normal water to acid. Pour the mixed acid stain right two gallon pump because of the plastic parts. It is vital that there be no metal for the applicator or spray wand since hydrochloric acid is corrosive for you to metal. For hand trowelled floorboards, dilute the stain with water by using a ratio of one element stain to four pieces water. For machine-trowelled flooring surfaces, the mixture will are more concentrated at a ratio of a single part stain to one particular part water. Adding water will also let you control the depth involving color. Test the sprayer outside to be sure a nice even flow before with it inside.
Step 4: Implement the acid stain concrete floors
When applying the acid stain on the floor, keep the spray wand with regards to 18 inches above the bottom. Spray in a random pattern and have the floor thoroughly soaked, but without puddles. The acid inside stain reacts with the lime deposits inside cement floor giving the idea multiple hues. Areas where there’s more lime inside cement will render dark hues of color. Let the first coat to dry completely approximately an hour, and then apply an extra coat. Repeat this process prior to the floor reaches the ideal color.
Step 5: Neutralize the Stain
Neutralize the hydrochloric acid stain on to the ground by spraying the floor with a variety of four parts water the other part ammonia. Apply this ammonia-water mixture which has a clean two-gallon plastic push sprayer.
Step 6: Clean the bottom
Allow the floor for you to dry again and cleanse the floor using a new clean mop. Vacuum up any extra water and enable the floor to absolutely dry before sealing.
clean up floor using clean steamer and vacuum up normal water
Step 7: Seal the bottom
stamped concrete sealer of the floor guards the concrete from foodstuff and everyday wear and also enhancing the color in the acid stained floor. Many kinds of concrete sealers works extremely well on the floor. In such cases a clear high high shine water-based sealer was applied. Applications differ with the sealer so be sure to visit the manufacturer's instructions. By using a paint roller, apply the sealer on the floor. Apply the sealer throughout multiple thin coats in lieu of one thick coat to be sure a better bond. Reapply the penetrating concrete sealer floor guards stained concrete
Step 8: Get rid of the Masking and Reinstall your Trim Work
After the floor has completely dried for 24 hours, remove the masking cardstock and reinstall the lean work.
When you are thinking of buying your concrete countertop sealer can recommend http://www.fabcrete.com/concseal.html for thousands and good advice.
