Secrets And Guide To Installing Your Glue-Down Cork Flooring Tiles

Posted by articlelink01 on March 12th, 2015

Installingcork tilesis as good as its undersurface. This implies that it will be weird to install your tiles on a rough surface when the tiles are smooth! Consequently, it is absurd to install them over vinyl, linoleum or plank flooring. You can only proceed with the task on a flat surface that is free of moisture. Hoping that you are informed on preparing the surface and screwing plywood underlayment to a minimum thickness of ¼ ¼ inch over your current floor, let us find out how you can carry on with the installation.

How to install glue-down cork tiles

Toinstall cork flooring, you must have gotten the surface ready to the level of applying a suitable adhesive. So, you should apply adhesive on the surface that you hope to complete within a single working period. With each section completed, you can lay your tiles on the surface then set them. When you want to proceed from the point, you paused at, simply butt a tile next to the finished surface then shove it carefully into the adhesive. Remember, you will not be able to budge a tile once it is fitted so, work with utmost caution. Use rubber mullet to tap a tile and mate the surface.

Use a simple home-made jig to make clean and straight cuts on the tiles. Align the tile with your mark then hold your knife straight (90 degree surface with the tile), pull it repeatedly on the surface till it cuts through the tile. Use your grit-sandpaper or paste wax to finish the work by sanding off high points and ridges. With this, you will successfullyinstall cork flooring.

Helpful secrets to get high quality and durable installation

You should first check on the age of your current flooring. If it is a glued-down base that was established before the 1980’s try to find advice from the health department. Most of those surfaces contact adhesive or asbestos that is hazardous when it becomes airborne. Fortunately, the health experts will help you to healthily remove and dispose them.

You have two types of adhesives to use; mastic and contact cement. The latter is rolled on the surfaces, allowed to dry then you can install the glue-down tiles after which; you cannot remove it. On the other hand, mastic is a little more forgiving. You trowel it on the underlayment and it allow you to move any misplaced tile. Fortunately, every manufacturer suggests an adhesive, and they will warranty that the tiles if you follow their instructions!

Rents (heavy surface rollers) should be your perfect friend when installingcork tilesbecause they help to create a uniform bond between the adhesive and tiles.

If you happen to fix your tile on a wrong spot, make use of a firm-blade scraper to not only dry but also to scrape it up. Then, you can add new adhesive to the affected surface and repeat the installation process.

If you are among the thousands of people who want to give their floors a new look with cork tiles, visit http://icorkfloor.com/, you will get expert help, and you can advise. Alternatively, you can visit other WebPages that deal with install cork flooring and get relevant information that will help you to make shrewd decisions.