Troubleshoot Common Garage Door Opener Problems: Expert Advices!

Posted by Secure for Sure on April 20th, 2021

When your garage door opening system stops working, the cause of the problem is usually quite simple to understand, and the solutions are usually quite easy. To make the task easier, we bring you the list of most common problems, and their solutions. In case the matter is out of your reach and skills, you will need to consult professional garage door repair professional.

Problems with the remote control

If the garage door does not respond while the remote control or wall switch is pressed, it means an interruption in the power supply. Check the outlet where the door opening is connected and check that the cable is connected all the way. It is also possible that the circuit breaker or fuse that controls the door opening circuit has tripped or burned. If you find that other lights or electrical functions in the garage are not operating, it is a sign that there is a short circuit at some point in the system.

The garage door does not work with the remote control

There are several possible solutions when a remote control or mounted keyboard stops operating the opener. It is possible that you are out of range of the antenna inside the garage. Modern garage door openers are essentially small radios that operate at around 315mH. If the door works well with the wall switch, it is likely that the battery needs to be replaced on the remote control. Each garage door opener has a slightly different method of reprogramming.

Garage door reverses immediately after touching the floor

Often, the garage door immediately jumps up after touching the floor. Adjust the closing limit adjustment screw on the door opening motor in small increments until the door stops when it touches the floor. Damaged or rusted rollers can also create additional friction. Check that the rollers are in good shape and well lubricated to avoid this problem.

The garage door does not open in winter

Sometimes a garage door stuck in winter. If this happens, look for a screw on the motor unit to adjust the sensitivity of the opening device. Especially in winter, when the rollers can become stiff, the door opener may refuse to open. Lubrication rollers can also help with this problem. Methods for adjusting the sensitivity vary. Consult your owner's manual for instructions.

The garage door does not open completely

When the garage door rises correctly, but stops immediately, the solution is to move the upper limit switch towards the motor unit. This switch is usually a touch lever simply mounted at the end of the track near the engine unit. And if it is too far away, the engine will stop the door before it opens fully. Damaged rollers can also cause the door to stop before opening fully.

Garage Door Services Dresher | Garage Door Services Feasterville Trevose | Garage Door Replacement Norristown

So, now that you know the possible causes and the solutions, it will not be a problem anymore. However, it is suggested to hire professionals to do the job. Contact with “Secure For Sure”, the best garage door repair company, having more than 15 years of experience. If you are looking for budget friendly service, 100% satisfaction, and great support, Secure For Sure is the name.

Like it? Share it!

Secure for Sure

About the Author

Secure for Sure
Joined: August 11th, 2020
Articles Posted: 87

More by this author