Instructions that might be followed to refill your cartridge by sos cartouches

Posted by John on September 7th, 2015

The best method to re-fill an ink cartridge would be to buy an ink re-filling package. This can be bought from any online shop selling ink cartridges. In addition to this kit you would discover the necessary tools and also a set of instructions how to go about filling-the-empty-ink - cartridges.

Here are some simple instructions that might be followed to refill your cartridge and it is not very complicated.
1. Draw the ink associated with any one colour by using the syringe provided within the re-fill kit. Ideally, this will be done over the actual sink. This is to make certain that even if some from it spills over no paperwork, clothes etc. gets destroyed. The amount of printer ink each printer holds usually varies based upon its manufacturers. For Instance, in most Epson ink jet printers the black cartridge retains about 17ml of ink and also the colour cartridges hold around 8ml. Please refer towards the instructions on your refill kit to check on how much ink ought to be injected into the cartridge at soscartouches.

2. A small hole must be made on top from the cartridge, one for every colour chamber. The hole should be towards the top of the cartridge near the actual label. The needle ought to be pushed into the hole and also the ink injected slowly. When the ink is not shot slowly, it could lead to foaming and air bubbles might be formed. If this occurs, the re-filled cartridge is probably not able to print.

Extreme caution: If this happens, contain the cartridge over a waste paper basket inverted and swing upwards and prevent suddenly. This could rectify the issue. If it doesn't then you may clean the ink mind with cleaner or attempt soaking the heads. This may remove any dry ink that's clogging the ink heads and permit the ink to circulation freely again.

3. The re-fill holes do not need to be sealed, as there are already breather holes along with the cartridge.

4. Any ink that's left over in the syringe could be returned to the container. The syringe needs to become cleaned with water as well as dried properly before utilizing it for another colour. It may be handy to use various syringes for different colors.

5. Once the refilled cartridge is positioned back in the inkjet printer, run the cleaning cycle 1 to three times. If there is any kind of gap in printing, the cycle could be run some more times till the issue is rectified.

Before placing the refilled cartouches lasers back to the printer, you could hold this upside down just to ensure ink is not dripping from the sponge.

Here are a few things that must definitely be kept in mind prior to re-filling a cartridge

1. The cartridge must be refilled before it is totally empty. If this isn't done, the cartridge can dry up completely and get blocked.

2. It might be smart to place the refilled cartridge to the printer and leave it alone overnight so the pressure in the cartridge may stabilize.

3. While making the holes towards the top of the cartridge, to provide ink, please make sure you don't hit it too hard or it may crack open the cartridge and allow it to be worthless. It might also create a hairline crack and permit some air in, which would dry the printer ink out prematurely.

4. A few of the newer models of printers possess a green chip in their own cartridges. Looking at the cartridge closely it's possible to spot this chip. They're usually known as "Intellidge" cartridges. The chip monitors the ink levels within the cartridge and notifies the computer once the ink levels are reduced. A resetting chip may be used to reset the memory about the chip. With the help of the chip, the printer recognizes the cartridge to be full and allows the actual refilled cartridge to printing.

A refill kit is considerably cheaper than the usual new cartridge and obviously promises a lot more than just one re-fill. Therefore, it is, easier on the wallet, keeps us from including more useless plastic towards the environment and increases the life span of a cartridge.

The re-fill kit typically consists of:

1. Bottles of Printer ink
2. A bottle associated with cleaning solution
3. The 2 part syringe
4. A users manual

Something to consider before buying refilled cartridges

There are several cartridges sold with the actual "Single Use Only" label. It is illegal in order to refill these cartridges with every other ink. This is usually present in Lexmark cartridges. If these types of cartridges are sent with regard to refilling or refilled cartridges tend to be bought, technically one could encounter legal charges for doing this. The cartridges that aren't marked "Single Use Only" usually come in a higher price.

For such cartridges Lexmark provides a 20% reduction in price when the customer agrees to send the cartridges to Lexmark.

This does not imply that using refilled cartridges is illegal by any means. All one needs to take into consideration is whether the maker has prevented a 3rd party refilling for their personal cartridges. This can be understood easily by taking care of any labels such because "Single Use Only". When there is no such obvious content label, it is absolutely okay to go ahead along with refilling the empty printer ink cartridges.

For more information about sos cartouche contact us here à
http://soscartouches.com/en