The Simplicity Of Keku Wall Panel FixingsPosted by Olsen Velasquez on May 14th, 2021 Have you ever gone into a modern office block or perhaps a shop and wondered what sort of wall panels seem to have nothing holding them onto the wall? Often there isn't any screws or connectors visible which are holding these phones the wall. So how is effect achieved? A period of time ago achieving this effect could have been unthinkable and you might have found some type of visible fixing at the top and bottom with the wall panels holding them about the wall behind, but this did look unsightly unless the screws heads were filled over. However in filling them in you had two problems, firstly getting a colour match while using filler was very hard. Secondly in the event you filled them in it made the panels very, very hard to remove in a hurry, which could certainly be a problem if you necessary to reach any electrical equipment or water pipes sat behind them in a rush. One German company recognised the necessity to possess a wall panel fixing system that allowed panels to become firmly fixed with a wall with no visible fixings showing, but in addition allowed these phones be released quickly in the event with the need to take a panel off. This has proved to get a concept that shop fitters love using mainly because it gives this type of clean look. her latest blog works very merely by having lightweight aluminium "I" cross section beams that seem to be like mini RSJ beams fit. These come pre-drilled with holes and are screwed for the real wall. A load bearing frame component will then be attached to the beam and also the relevant panel component attached on the panel, this then means the panel are able to be slid into place with all the panel component clipping straight into place while using frame component. This forms a link, which in effect locks the panel towards the wall, but by just sliding the panel upwards the ingredients come apart releasing the panel. The undeniable fact that the beams come pre-drilled for simple assembly entails that this frame components may be attached to the beams in a wide array of heights. faux timber panels in turn allows plenty of flexibility when hanging the wall panels. The end result is wall panel fixings that can be fixed firmly, but invisibly available but allow for a really high dimensional accuracy, with gaps which are precise, yet could be varied in width.Like it? Share it! More by this author |