Electrical Solutions: 3 Reasons My Lights Don't WorkPosted by Butt Futtrup on May 14th, 2021 A few days ago a good friend called. He explained in my opinion that the flood light in the front of his house wasn't working. brisbane power electricians informed me he changed the bulb. We scheduled a time to the service call. Upon arrival I removed the switch plate. I tested the circuit for voltage. My voltage meter showed 122.5 volts. I returned to my truck. After retrieving a single-pole almond switch, I removed the present switch. After installing the newest switch, I recognized that this light still have not. I retrieved a ladder through the truck. I found a lamp within the den and removed a working bulb. After installing the functional bulb, the fixture produced light. Sometimes customers call saying they desire a breaker. I have to ask, "How are you aware?" Through further discussion the two of us realize your situation will demand more investigation. One customers 3 way switch problem stemmed coming from a very different light. The daisy chain fashion of wiring had eliminated the ability source. We took out other devices before he revealed another light which had quit working. The neutral was no longer coupled to the circuit. I wrote down this checklist to aid the novice troubleshooter. 3 Reasons My Lights Aren't Working: My lamp is burned out. electrician brisbane southside is no longer working. There is no voltage present in the light. I happen to be troubleshooting residential lighting circuit's for years. There isn't fool-proof method for your process. You can eliminate some headaches by following these steps. Test your replacement bulb before installation. I have placed another bad bulb into a fixture. More Info causes confusion. You can next remove the switch plate. Test for voltage with the switch. The voltage can be transferred via a solid insulated wire. If voltage is found, get rid of the insulation form both sides of your jumper wire. You can touch both ends on the screws simultaneously. If the switch is defective, the sunlight should produce rays of light. After replacing the switch, the sunlight work. If doing this fails, you have to take away the light fixture. Once the fixture is slowly removed, test for voltage. You will need to turn the activate. This will complete the circuit. I have had not many examples until this method didn't solve. It is easy to get confused if there is not any real plan of action. Troubleshooting isn't impossible. It can be challenging.Like it? Share it! More by this author |