Do-It-Yourself Asbestos Removal TipsPosted by Rask Todd on May 21st, 2021 Towards the late 70s and early 80s a major surge begun, toward having asbestos structures and buildings removed. Around the world, governments began to ban and gradually phase out the production and usage of asbestos in manufacturing. Since that time, lots of asbestos have gotten taken off structures, although there's ample more that remains in place. To live in a house which has asbestos untouched or undamaged doesn't unavoidably pose any health risk. According to the US National Cancer Institute, most persons that are suffering from key asbestos-related health complications have already been exposed to asbestos over extended durations of time, for instance factory employees where asbestos materials are produced. However, before you opt for that DIY job, it would be worth to ask yourself the following questions. - Are you conversant with the other alternatives like sealing, painting or covering it with some non-asbestos containing material? - Will you be in a position to adhere to the laws and safety procedures while you work with asbestos? - Should you employ an approved asbestos remover? Before you undertake any renovations or work involving asbestos, do thoroughly check and be prepared with the appropriate equipment. As a homeowner you might remove ten square metres of bonded (non-friable) asbestos or less without having to get yourself a certificate. However, you still are obligated to take the requisite safety precautions. If the asbestos to be removed exceeds 10 square metres, then you have to get a certificate before you remove it. Another option is always to hire a qualified contractor who's currently holding a certificate for asbestos removal. You generally do not require a certificate for just about any non-removal work such as removing bathroom wall tiles, drilling a hole or finding your way through any painting. You however must still set up precautions for preventing asbestos fibres from getting airborne, besides sticking to general work safety procedures. The following safety measures have already been strongly recommended when removing an asbestos sheet: - Cordon off the entire work area with sturdy barrier tape to make sure those persons that are unprotected cannot enter into the area. - Persons who are doing the removal ought to put on appropriate protective equipment and gear for instance a respirator and disposable coveralls. - Prior to the removal, wet down the asbestos material, except of course when that could pose a danger (e.g. on a roof). - Breaking or damaging bonded asbestos should be prevented. - Utilize plastic drop sheets and then using a damp or wet rag, wipe all surfaces after removal. - Proper decontamination should be carried out after removal. This entails disposing coveralls along with other disposables as asbestos waste plus comprehensive washing. - Where feasible, the removal work should be carried out in areas which are well-ventilated. The following should as far as is possible be avoided: - Sawing, scraping, sanding, or drilling holes in materials containing asbestos. Furthermore, power tools of 240 volt and above must never be utilized because they are susceptible to dispersing fibres in to the open air. - Usage of powered coarse brushes or pads for stripping off wax from the asbestos flooring. asbestos removal services melbourne - Disposal in the domestic garbage bins of asbestos waste. - Recycle, re-use or illegally dumping materials containing asbestos products.Like it? Share it! More by this author |