A Step-by-Step Guide: How to Remove Old Floor Tile?

Posted by David John on September 10th, 2021

Do you know what’s the toughest job while remodelling or renovating your place? Removal of old floor tiles. Apart from being a tough job, it is a pretty expensive one too. Rather than spending a heavy amount, it is easy to learn how to remove old floor tiles all by yourself. However, we recommend you take proper safety precautions before performing the tile removal process. Make sure you have all the safety equipment in place!

Equipment Required For Old Tile Removal

During this process, you can buy a floor scraper and an angled steelhead. These tools come in handy when dislodging the old floor tiles from the adhesive. There are a few safety equipments that you will need to prevent any injury. Keep a handheld chisel, paint scraper, safety glasses, leather gloves, dust mask, and drop sheet ready.

In case you are stuck with any equipment or feel a bit lost during the process, get help from professionals in the UK.

How To Remove Old Floor Tiles: Step by Step Guide

Eliminating floor tile can be a troublesome and tedious task, and the difficulties frequently stay covered up until the process is complete. Depending upon the construction, the tile might be attached to exposed concrete, a pressed wood or bricklayer board underlayment or even attached to a formerly installed floor. Whatever lies underneath, needs to be removed along with the pre-installed floor tileset.

Stage 1: Remove installations 

Vacate the room and remove any installation in a way that might hinder the method involved with the removal of old floor tile. If it is near a washbasin or bathroom area, disconnect your supply to ease the process.

Stage 2: Find the beginning stage 

In case the tile was installed around a vanity or other semi-long-lasting heavy machinery or equipment, cover it with an uncovered edge before you start the tile removing process. In case the tile is one end to the other, it is essential to utilize a mallet and etch to break out a tile to start up with the starting point of the installation process. Tiles might be fixed using glues or mortar and may come up effectively or require exertion, contingent upon how they were attached and the kind of underlayment used. With the help of a hammer, break it down to eliminate tiles.

Stage 3: Get rid of the tile 

From the beginning stage, keep on pulling up tiles. Store the tiles in a garbage bin or in a pile to limit the mess in the area. Recollecting the tile can be heavy, and an overloaded waste container will be hard to pull away.

Stage 4: Access Underlayment 

Since the tiling has been connected now to a substantial floor or subfloor, a pressed wood underlayment is required. An unseemly or harmed underlayment ought to be eliminated, however, some of it can be reused efficiently. Access the underlayment and remove it to uncover the sub-floor, if required.

Stage 5: Clear trash 

With the help of a brush or a vacuum cleaner get rid of all trash off of the floor. Make sure the floor does not have any particles left or it can cause injury or discomfort in upcoming steps.

Stage 6: Remove any visible nails 

If you have removed the surface completely, it might very well be essential to get rid of any nails that are present on the surface. Be extremely careful while removing them from the floor to avoid any injury. If by any chance you get a cut, make sure to get medical help as soon as possible.

Stage 7: Inspect floor 

When you have got rid of the floor tiles, examine the subfloor for chips or damage that might be fixed before another floor is installed. Fix or replace any bad wood or divots in substantial floors. The subfloor needs to be smooth and harm-free before another floor is installed.