Replacement of Garage Door Springs

Posted by Secure for Sure on September 21st, 2021

When the garage door springs break, replacing them is the only option.

The tension springs are located next to the hatch of the overhead door and are provided with a pulley and a cable. On the door, torsion springs are installed, and a long round shaft passes through them, with a cable wheel at each end. Torsion springs are generally used for more extensive and heavier doors.

Replacement of extension springs

Installing Extension Springs - The Safety Cable

You may have got a new set of cables with your springs. The security cable attaches to the bracket on the head of the door, possibly using a hook and cable tie. There might be a guide hole on the yoke. Thread the cable through the guide hole, then through the spring. The cable then attaches to the hanger bracket at the end of the track. It doesn\'t need to be tight, so it doesn\'t get tangled.

With the two springs installed, you can release the clamps and slowly lower the door. Make sure the pulleys and cables move correctly and do not jump off one or both pulleys.

Thread the cable

If the wiring has been removed and needs to be threaded, follow these instructions. Someone has to hold the spring until everything is threaded. To begin with, append the clevis and pulley to one finish of the spring. Utilize the bolt you took out and two wrenches to fix it. Then, you\'ll need to append one finish of the spring to the snare on the holder section.

Hold the spring in the approximate area with your partner. There is a loop at the end of the cable that hooks into the pin at the bottom of the garage door. The cable then goes to the pulley, which is attached to the bracket on the wall. The cable is threaded inside the pulley. Then it connects to the hook on the bracket, which is attached to the air track. The location of the hook may need to be adjusted.

It\'s possible you had to loosen the cable clip at the hook. Tighten the cable and adjust the hook so that the spring is high but not under tension. Install the safety cables. With everything hanging, carefully lower the door and watch the cables stay in place. After you finish replacing the garage door springs, look at the garage door spring adjustment if your door needs adjustment.

It will be easier to install extension springs if the cable is threaded and suspended to the side. You may require assistance. One person holds the spring, while the other lifts and holds the entire cable. Lift the spring and cables toward each other by attaching the spring to the hook or clip on the hanger bracket. Finally, carefully put the clevis on the end of the spring and bolt the clevis to the pulley.

Replacing the torsion springs

Garage Door Spring Replacement Easton | Garage Door Opener Repair Valley Forge

Most homeowners shouldn\'t try to adjust or replace garage door torsion springs. Indeed, the problem is that they must be handled when the door is lowered, and the springs are under tension. When you release the adjustment screw, you should have a rod in place and hold it to control the spring force. This form of garage door spring replacement is not suggested for the ordinary homeowner. It is recommended to hire a technician to replace garage door torsion springs.

Do not hesitate to contact a professional if the repair presents risks or doubts about your understanding of the explanations.

Like it? Share it!

Secure for Sure

About the Author

Secure for Sure
Joined: August 11th, 2020
Articles Posted: 87

More by this author