Easy Steps for Wood Fence Installation

Posted by sentryfence on May 23rd, 2016

When you install a wood fence in your yard, it not only increases the beauty of the landscape due to the soft tone of wood, but also enhances the value of your property. Even though the installation of a wooden fence is labor intensive, still if you follow some vital steps, you can ensure easy and convenient installation.

Things you will require

· 16 p galvanized nails

· Hammer

· Pencil

· String line level

· 24 inch hand level

· Wheel barrow

· Hoe

· Ready mix concrete

· Rock bar

· Posthole digger

· Shovel

· Measuring tape

· String line

· Small marker flags

Steps to install a wooden fence

· Start with placing a small marker flag where the fences Hamilton will begin. At the end of the fence section, place another flag. Between the two points, stretch the string lines and ensure pulling it taunt to ensure that there are no curves in the straight line.

· Next step involves laying the string on the ground. Using the measuring tape, ensure proper laying out the positions of the posts. Get this information from the manufacturer of the fence.

· In the next step, you require digging a hole at every flag placement. Ensure digging the hole deep which you are capable with the shovel. Ensure that the diameter of the holes is approximately 4 to 6 inches wider than the post which you are placing on the ground.

· With the use of a rock bar ensure loosing the dirt and remove the posthole digger from the hole. Continue repeating the process till you reach the ideal depth.

· In the next step you require placing the entire posts in the hole and mixing the concrete with the use of hoe and wheelbarrow. Permit the concrete to fully cure, usually overnight.

· Now you require stretching the string line on the completely cured fence posts. Discover the level positions of the two end points of the strings. Ensure adjusting the strings till the bubbles reach the center point of the string.

· Now you need marking each post with the pencil that will denote your level line. With the use of the 16p galvanized nails nail the fence frame 2 by 4s to the right centerline measurement that is provided by the fencing manufacturer.

· At the end of each fence section, ensure attaching a fence picket. From each of the picket board on top of the board, stretch the string line. At each fence picket board, the line created by the string will be top level line.

· Finally, place each fence picket board in place via raising the top of the picket to the string line.

To ensure effective fence installation, you can even plan to hire a reliable fence company in Boston!

Source: http://www.articlesbase.com/home-improvement-articles/easy-steps-for-wood-fence-installation-7446944.html