Ultrafine Vertical Mill Maintain Regularly

Posted by birder2525 on August 24th, 2022

The partition board or grate seam is blocked by some sundries or debris. In severe cases, it is completely blocked, and the grate hole becomes smaller, which causes the ultrafine vertical mill to be "full grinding". If the ultrafine vertical mill is not maintained regularly or is in disrepair for a long time, the partition plate may be partially broken off or perforated, causing the steel balls to pass through the warehouse and reducing the grinding capacity. 

How to solve the problem of "full grinding" of ultrafine vertical mill? Now that we have understood the reasons for the "full grinding" phenomenon of the ultrafine vertical mill, we can take specific solutions to eliminate the fault, eliminate the "full grinding" phenomenon of the ultrafine vertical mill, and ensure the normal operation of the entire beneficiation production line. 

The common method is to reduce the amount of feed and ensure smooth ventilation of the cylinder. If the effect is not obvious, the feeding can be stopped immediately, so that the ultrafine vertical mill runs with little or no material, and generates enough heat to evaporate the water in the material, and at the same time, the steel balls, the lining plate and the grate of the partition plate are adhered to the gap. 

The material is subjected to thermal expansion and cracking, and falls off under the repeated impact of the steel ball, thereby reducing the blockage of the sticky ball and the partition board.