High Pressure Misting and Fogging Techniques

Posted by dimisor on December 3rd, 2022

A misting program should really be provided to you with all areas and accessories, ready to set up with a minimal number of resources (screwdrivers and wrenches).

Open all containers and tubes and make certain the areas for the misting program haven't been missing or ruined in shipping. Have an excellent review of the installation handbook and areas to be installed. The misting process pumping product should come fully built - ready to use the moment you source water and capacity to the misting working unit.

Place the fogging system putting unit in a place that may protect it from abuse and or injury (they can be simply attached to the wall). The location picked must be where you could supply the water and energy expected to work the system.

Connect Gravista the mainline to the misting model and shift on with the installment from there. Some installations work with a respond line and some models require stainless steel for the mainline (line from the misting putting system to the area where in actuality the nozzle range will soon be installed). If the misting process nozzle range is to be mounted applying metal suspension wires, install the cords by attaching them to equally stops of the region to be misted. A turnbuckle at one conclusion can enable you to tighten the wire and a stainless help wire should be installed every 10 legs to keep up an amount line.

Mount the region valves and or baseball valves safely to the suspension cable or perhaps a strong surface. Begin installing your misting lines. If your misting program is an "all metal system" you will undoubtedly be using a Swagelok type fitting to join the 20 foot programs of nozzle line.

Many misting programs use steel accessories to become listed on the 20 foot lengths. If your misting program was made for brass fittings, you will also be supplied with plastic "O" rings. It is critical to use the "O" bands on both sides of the unions to make sure a water tight system. Do not around tighten the union, this could trigger the "O" ring to disintegrate and enter your system. At the end of one's nozzle point you can put in a strain valve.

When all your misting nozzle lines are fitted you need to "flush" all the lines to make sure no dirt, etc. is stuck within your system. While flushing, start installing your misting nozzles from the closest nozzle to the putting system and perform your solution to the farthest nozzle. At some point the water stress (coming out from the nozzle increasing hole) will soon be excessive to install the nozzle. Closed the misting system off and end installing the remaining nozzles.