Buy Hook and Loop Sandpaper Discs to Make Your Sanding Machines More VersatilePosted by Harry Jackson on June 5th, 2017 As a part of their job, woodworkers use many tools and supplies to construct and finish a wooden object. Most of the tools like claw hammers, layout squares, chisels, screwdrivers, levels, nail sets, sliding bevels, block planes, utility knives are used to make an object but the real shape of any object comes out only when it is finished. The main purpose of finishing an object is to smooth out its rough edges and make it attractive. Finishing tools cut the rough edges by using very sharp and fine blades. One of the common finishing tools used in woodworking is sander. It is available in the form of a kit in two types as drum sander kit and molding sander kit. While performing the finishing of an object, different materials are used to do the job. Sandpaper is one of them that has many uses at the finishing stage of the woodworking projects. It can penetrate the substrate, even out chipped material from a scratch and level old surfaces or paints. When sandpaper is used to finish an object, it is made wet so as to sweep away the abraded surface and grit. Sandpaper is attached to the sanding machines through hooks and loops that make it easy to change them when required. And, if it is not possible to get attached with the machines, converter discs are used to make it adaptive to the sanding machines. Like it? Share it!More by this author |