Some tips for maintenance and precautions of printer

Posted by zhou on February 7th, 2018

Last week, the printer office worker teach us some tips for maintain the printer. Actually cxpect choosing good quality toner cartridge, for example toner hp cf217a, office supplies, office equipment, office equipment and other daily office equipment protection is necessary, but not everyone can grasp. Brought to you today, is the stylus printer break solution and routine maintenance.

1, often cleaning the print head
Long-term use of the printer, the ribbon of ink and dirt will plug the printer's guide pinhole, so that the printer during printing resistance increased movement. This easily lead to the printer's print needle breaks needle failure. Therefore, the general printer should be considered in the use of 3 months after cleaning, if the use of high-frequency printer, use after 1 month should consider cleaning.

2, choose to use high-quality ribbons
Due to the high-quality ribbon tape base no obvious marks, the connection is pad technology, uniform ink; and low quality ribbon tape base will have obvious double-layer joints, and the ink Poor quality, easy to cause broken needle. Therefore, we generally should choose to use high-quality ribbon boxes and ribbons, do not use inferior ribbons, and should be carefully checked before use.

3, pay attention to the use of ribbon time
If it is used for too long, even high-quality ribbons will show less elasticity, longer slackness, even wrinkles and pores, making them very susceptible to broken needles. Therefore, we should pay attention to the use of the ribbon time, at the same time, once found the above phenomenon, we should consider replacing the ribbon.

4, try to print less wax paper
Long-term printing stencil is a major cause of broken pins in the printer. Therefore, we should try to print less wax paper, even if you want to print wax paper, but also pay attention to the first layer of tissue paper below the wax paper removed, pad a piece of paper, to reduce the horizontal resistance of the print head resistance. And after printing, it is necessary to promptly clean the rubber roller with anhydrous alcohol to ensure that the word roll smooth.