The wiper wipes the more dirty, easy to solve yourself

Posted by topexwiper on April 25th, 2018

Many people will find their own wipers are not clean after using the car for some time. Sometimes it starts to rain. This glass is not full of water, but after it is scraped, there will be dirty things left in the glass. on. What's going on here? Next, we will introduce you to a method that can be used for either a Flat wiper blade or a hybrid wiper blade.
The first reason is that the glass is not clean. In the ordinary washing time, the glass is not cleaned well, and the surface of the glass has been stuck with tiny dirt, such as dust, small stones and so on, which will cause the cleanness of the glass surface to appear to be reduced. The rough glass surface is not only not clean. And it will hurt the wiper strip. For dirty scrapings caused by dirty glass, go to the car wash shop and have them clean with a special cleaning glass lotion.
The second, that is, what the author wants to focus on is that the wiper strips are rough. The wiper strip from the original car is imported. If it is properly maintained, its lifespan can definitely reach 5 years. Therefore, in the short-term, the wipers are not clean, and many are because they are not well maintained.

How to maintain it? The most important thing to notice is the timely removal of dirt on the wiper strips, such as sand or something. The wiper wipes the water with fine sand, which is equivalent to using sand to wipe the rubber strips. It will take a long time before it will be scarred, the finish will be reduced, and the fur strips will no longer be clean.
Because the small sand in the middle creates voids and friction, so each time you wash your car, you must use your own hands to clean the tiny sand on the wiper strip with a clean towel, because the car wash will not Wipe your wiper strips for you.

In addition, summer parking, try not to exposure, because rubber products are most afraid of direct ultraviolet radiation, easy to aging hard.

Some small tricks, the overall summary of a brief summary, to introduce a method for you to restore your wiper as new:

First, put two wipers upright, insert a key, and turn the key to turn on the power, but instead of starting the car, turn off the power, pull out the key, and then move the wiper handle on the right side of the steering wheel down. The wiper will rotate and stay in a vertical position. At this time, you can lift the wiper by hand, which is to erect the wiper.
We must pay attention to this time! The length of the two wipers is not the same, we must remember the two respective positions, do not reverse when loaded back. At this time, press the square tab of the wiper with your left thumb and force it in the right direction with your right hand to pull out the wiper. Two wipers were removed. The

Then we have to ask for a secret weapon: a 2000-mesh sandpaper. Water sandpaper can be purchased in various paint shops, the price is very cheap, buy one for a few years. Here, the author does not describe the specific brand, so as not to be suspected of advertising, we tear the water sandpaper into small pieces, each time using a small piece is enough. Saturate the wiper and water sandpaper with clean water and grind the strips of the wiper with water-sand paper while moistening.
Note that the wiper strip is like a kitchen knife. You must not only grind the two sides of the strip, but also properly grind the front edge of the strip. Time does not need to be long, about 5 minutes on it. Do not reverse the position of the wiper when installing it. After the installation is back, turn on the power and re-dial the wiper handle. The two wipers will return.
After the author's introduction, everyone is not aware of his own wiper! If your home wiper also has such problems, you can act now and go home to clean your own wipers so that afterwards it will rain and you will see a clean window glass!