How much electricity do voltage stabilizers consume?

Posted by servostabilizer on November 2nd, 2018

Servo Stabilizer have proven to be the perfect solution for controlling voltage fluctuations as it can handle both overload and under load of electric power. Using these stabilizers made by Servo Stabilizer Manufacturer can help in the prevention of many mishaps caused due to over and under load of power supply. Indian homes very often experience an irregular power supply where voltage fluctuates from high to low. These fluctuation, if not taken care of can damage our appliances and lead to high electricity consumption. When the voltage reduces, the current that goes in the appliance increases which has the possibility of damaging the appliances. When our electrical appliances do not get the required amount of voltage, the consumption of energy in the appliances increases that leads to increased energy wastage. This damages our electrical appliances that affect our electricity consumption.

To understand better how a Servo Stabilizer Manufacturer created Servo Stabilizer controls the voltage and plays a role in our electricity consumption let us discuss about high and low voltages. High voltage is a situation in which the current flow is higher than the required amount voltage for an electric appliance; thus in this case the stabilizer needs to be designed by an expert Servo Stabilizer Manufacturer to operate by reducing the voltage. Low voltage on the other hand, is the opposite; in this case the current flow is lower than that required amount by the electric appliance and thus the Servo Stabilizer needs to provide an increased voltage.

Apart from low and high voltage, there is a third factor that affects the optimization of voltage and requires the use of Servo Stabilizer, which is the imbalance of phase voltages. Unbalanced phase voltages can have an extremely bad impact on, heating of the motors or the wiring and increased energy consumption.

Thus with problems like low and high voltage fluctuations and unbalanced phase voltages there is a need for voltage optimization to save our electricity consumption. This is the reason Servo Stabilizer are used to control our electricity consumption.

Servo Stabilizers created by Servo Stabilizer manufacturers are installed because they help in balancing the voltage in all three phases. These Servo Stabilizers don’t only balance voltage in all three phases but also increases our investment on the stabilizer by helping us to save energy and this directly reduces our electricity consumption.

But there is a condition that comes attached with stabilizer that is- it is advised to get a Servo Stabilizer that fulfills the requirement of the entire house or office. As a stabilizer that is lower than the one required, when is used for a longer period of time, it can in the long run lead to a higher electricity consumption.

So how much electricity does a servo stabilizer which controls the voltage consume?

Electricity Consumed by Servo Stabilizer with Voltage control

The best Servo stabilizer manufacturer- Servo Star suggests that electricity consumption by Servo stabilizer depends on how energy saving the stabilizer is. Most Servo stabilizer manufacturers design the Servo Stabilizer with voltage control up to 95-98% efficiency. This means that the Servo Stabilizer consumes approximately 2-5% of the maximum load. So, if you leave the stabilizer on (that is not based on the requirement of the house or office) for 24 hours it can result in a lot of electricity consumption.