Know The Working Process Of A Carpet Cleaner Christchurch

Posted by jian sun on January 16th, 2019

How a carpet cleaner works can be highly intriguing. If you know about this then you can check whether the clearer is doing it right or not. A carpet cleaner, also known as a carpet shampooer and extractor, is supposed to remove all dust and dirt that may be deeply embedded within the fibres of the carpet to create stains. For optimal results, the cleaner will work with different machines and approved cleaning agents. The process followed includes pre-treating the carpet by spraying cleaning solutions on it. It is allowed to soak or dwell well for about 15 minutes. After that, the cleaner will pump water into the carpet to extract the dirty fluid with a highly powerful vacuum cleaner.

Steam cleaning process

Most of the times a qualified and professional Carpet Cleaner Christchurch will follow the steam cleaning process which is why they are often referred to as ‘carpet steam cleaners’ or a ‘steam carpet cleaner.’ Sometimes, they are simply called ‘steam cleaners.’ However, a true carpet cleaner will use dry vapour steam. This is however ineffective for general carpet cleaning purpose. In general, a carpet cleaner will come in configurations that will allow then to clean with a big wand. They may follow the "walk behind" process that offers greater efficiency for wide cleaning paths. Often they will carry additional attachments so that in addition to carpets they can also clean other soft surfaces such as upholstery, curtains and wall partitions with the machines.

The key components

There are different key components used by a carpet cleaner to ensure Quality Carpet Cleaning Christchurch. These components will include a pump that generates the pressure to inject the water deep into the carpet. The pressure levels of these pumps usually range from 60 pounds per square inch to 500 psi. They will also have a vacuum to extract the dirty water solution from the carpet. These vacuums have motors of different configurations such as a single 2-stage motor, dual 3-stage motors, and three 2-stage motors. There will be solution and recovery tanks as well to hold rinse water and extracted dirt, water and cleaning chemicals respectively.

 A few other accessories

The Carpet Cleaner Christchurch will also use a few other components and different accessories. A heating unit is one such component that is used to heat the rinse water to a temperature as high as 210 degrees within three minutes. The heating elements in these units too come in different configurations such as a single tank to a double line heating models. In the single tank configuration the water is heated in the solution tank whereas in a double inline heating element the water is heated up as it exits the machine. As for the accessories, carpet cleaners usually use a large floor wand. This wand can range from 10 inches to 12 inches in width. Apart from that, there can be one or two jets to dispense and extract fluids.

Using a carpet cleaner

Before you use a carpet cleaner make sure that the following things are taken care of. The carpet should be vacuumed thoroughly before applying the cleaning solution. This will help in better dissolving of the grease and oils to make the final extraction easy. Also make sure heated water is used on stains but not on natural fibres.