The Best 3 Step Guide to Preparing Your Garden For Artificial Grass Installation

Posted by New Wave Flooring on February 22nd, 2019

Preparation is among the foremost aspects of installing synthetic grass Perth to create artificial lawns. This article offers an outline of the steps you have to follow to gauge the suitability of the ground and ready it for installation. It comprises taking precise measurements, assessing the conditions of the ground, and eliminating the current layer of lawn grass.

 1. Measuring

The area you are to measure should be marked off. It helps to mark the area off using a spray of sand or paint. When taking the measurements, it’s crucial to integrate a 100mm overlap over every single edge to cover the timber perimeter. Artificial turf is offered in 4 metre and 2 metre wide rolls and could be supplied in lengths that meet your needs and requirements. It’s critical to measure precisely and to calculate the exact width and length that’s required.

 2. Ground conditions/survey

Evaluate whether the terrain of the ground is liable to poor drainage. In such instances, to ensure your base is satisfactory, you must take measures to install appropriate and sufficient drainage. If you happen to be constructing a new sub-surface to contain artificial turf, you should integrate a little fall to help drainage (1:200 is perfect). Open textured (porous) Macadam is specifically suitable as a sub-base for every type of artificial turf. Paving slabs are never satisfactory when used as a base for fake grass in Perth. This is because, after some time, the slabs’ patterns begin to show above the grass’ surface. Slabs should be eliminated or covered with a thick layer of sand that’s coarse.

 Unbound aggregate (stone) bases that are well compounded are quite ideal when an artificial lawn is being built from scratch. This kind of base is always recommended. All unbound surfaces that drain and are stable as well as reasonably level, nevertheless, is ideally satisfactory. If the surface happens to be too rough, it could be screed using sharp coarse sand, before you lay the grass so that you end up with a flat smooth layer. Even though artificial turf can be laid directly onto your current lawn, as far as the drainage is satisfactory, this isn’t always satisfactory eventually. The natural grass dies off and its roots decay, bringing real unevenness to the surface of your lawn. Grass removal and the compaction of the resultant soil base can overcome this issue, particularly when you cover the soil with a layer of compacted grit sand.

 3. Lawn grass removal

Remove grass sod and any other materials and vegetation manually or hire a grass cutter to save effort and time. Grade the soil out to estimated levels eradicating all large protruding stones then compact firmly. You have to install drainage if needed then compact the ground with a vibrating plate which you can hire from any equipment hire firm.

 Once you have completed all of the preparatory steps that have been listed in this article, you will certainly be fully ready to install your artificial lawn using synthetic grass Perth. If you will love to know the actual steps for the actual installation process, keep returning to this page to read it one day.