These 7 Steps Will Keep Your AC Smoothly Running By AC Maintenance Santa Barbara

Posted by Travis Solomon on July 15th, 2019

In order to extend the life of your air conditioner, it is necessary to maintain the system. It will also help you save on energy bill. This will help you save money on early replacement. Don't forget an AC system needs special attention. Deferred maintenance could make you shell out more money. In order to avoid such break down, AC Maintenance Santa Barbara suggest 7 steps for a smooth running of your air conditioning system.

1. Turn off the power
Working around an active electricity appliance can be fatal. Thus, it is essential to switch off the power of the unit. Search for shut-off button around the compressor or condenser unit. In case of indoors, use shut off button to turn off the power.

2. Eliminate debris
In order to remove the debris, remove the fan cage in the exterior of compressor or condenser. Post removing the cage or fan grill, clear dry leaves, dirt and other debris from the unit. One can check this site if you are looking to hire HVAC professionals in order to provide preventive maintenance service to your AC.

3. Clean the fins
Start by removing the covers and use a brush to clean the dirt settled in the exterior surface of the unit. Thereafter, use a garden hose with gentle stream and spray the water inside out for eliminating debris and dirt buildup. Make sure not to use pressure washer since it can damage the fins In case of dirty fins, use a commercial cleaning spray.

4. Realign the fins
Air flow reduction could lead to low efficiency. If the fins are bent, straighten to increase efficiency. You can use commercial fin straightening tools or a butter knife for rearranging the bent fins. Make sure to use gentle movements while handling fins.

5. Clean surrounding areas
Replace the fan cage after cleaning and straightening the fins. Rake leaves, remove debris outside the condenser and trim branches and vegetation around the unit This action will ensure proper air-flow. To prevent dirt and debris built-up, cover the top of the unit. However, do not cover the unit completely as it cause moisture built-up which further corrode the unit. Furthermore, it can also encourage vermin infestation. Therefore, remove any cover when the unit is operating.

6. Level the unit
Over time the pad on which the unit rests starts collecting dirt. The out-of-level condenser can cause the failure of the system. Therefore, check the level of the unit. If the unit is not in a level, use rot-resistant shims to restore the level.

7. Clean evaporator coil
After working on the outdoor parts move inwards. When you move inside, you will find an evaporator coil door near the blower. You might have to remove the foil and duct tape and unscrew the door. Thereafter, use a soft brush to clean the coil and use commercial coil cleaner. The spray will form foam which will fall into the drain pan. Make sure to clean the drain pan with soap and hot water. In order to keep the drain clean for a long time, place a drain pan tablet. It also inhibits algae growth.