Tips for Spray Painting To Get Smooth Finishing Without Any Drips

Posted by Lewisham Smash Repairs on August 27th, 2019

Whether your vehicle paint job is glancing a little shoddier for wear, or you would like to modify of colour, In Canterbury spray painting your vehicle is a cost-effective method to provide your ride with an entirely new look. However, the difference among a correct spray paint job and a DIY disaster need research, planning and preparation. So if you are beginner, Use our car painting guidelines to give your vehicle a smooth new layer of paint, and a new lease on life.

What you will require

• A paint sprayer
• Safety glasses
• Undercoat/primer
• A clear coat lacquer
• A rag
• Denatured alcohol or mineral spirits
• 1200- and 2000-grit sandpaper
• Masking Tape
• Primer
• A cleaning solvent
• Enamel, acrylic enamel, or polyurethane paint
• Paint thinner
• A face mask
• Rubbing compound (optional)

Moreover, make sure with a Canterbury Spray painting professional before mixing any chemicals and to assist you to figure out the finishing colour. You desire to obtain the right ratios for the mixtures, depending on the size of your car and what you’re trying to achieve.

Remember if you have never used power spray gun earlier, then you must practice the spraying gun motion on the metal piece before trying to your car. When you apply the paint, hold the spray gun about six inches from the surface and spray in a far-reaching side-to-side action. It would help if you pushed the trigger when you are using the paint sprayer. If you compress the trigger while the sprayer is at rest, the paint will become thick and cause leakage.

Let’s have a look at the basic instructions that you need to use for spray painting the car-

1. Clean the vehicle and wash down the nearby area. If you are painting particular areas of the vehicle, secure those areas with the masking tape and paper.

2. Utilise the power sander to remove the previous paint, using circular motions. Manually sand the corners and another complicated region. Walk off from front to back and create the surface as smooth as likely so that you can get proper finishing of the paint. Next, wipe down the whole vehicle completely as Dust, sandpaper remnants, and additional remains will cause blots in the paint.

3. Combine the primers with the thinner and then apply from the top to down. It might take 2-3 coats to wrap the car surface completely. The primer will look like chalky on the plane, as a result, employ the 2000 sandpaper to level and clean it.

4. Clean the spray gun and wash down the primed surface with a rag somewhat dampened with thinners.

5. Execute 3-4 coats of the paint with similar sweeping strokes. Once more, every coat will take about 10 minutes to apply and 20 minutes to dry. Before applying the last layer, use the sandpaper and clean so that you can get rid of any residue.

6. Apply the clear coat polish and take away the masking tape while the lacquer is still wet.

Note down: If you discover any problem areas, sand them with the 2000-grit wet-and-dry sandpaper and again spray.

7. Once everything gets dry, rub the entire thing with a soft buffer, by a circular motion. Be alert not to continue in one spot too long, and it could damage the finish.

 So if you have any problem while painting your car, you may consult Canterbury spray painting professionals for the best paint finishing.