Electrically controlled hydraulic control valve maintenance and repairPosted by uuuseff on November 17th, 2019 The filter must be installed in front of the hydraulic control valve and it should be easy to drain the water. Hydraulic control valve is a self-lubricating water valve body, without additional oil lubrication, in case of damage to the main valve components, according to the following instructions for disassembly. (Note: the general consumption of damage within the valve products for the diaphragm and ○ ring, other internal parts little damage) 1. The main hydraulic control valve before and after the end gate valve closed. 2. Loosen the pipe fitting screw on the main hydraulic control valve cover to release the pressure in the valve. 3. Remove all screws, including the nuts of the necessary brass in the control line. 4. Take the hydraulic control valve cover and spring. 5. The axis, diaphragm, piston and other removed, do not damage the diaphragm. 6. After the above items are removed, check the diaphragm and ○ ring is damaged; if no damage do not subcontract their own internal components. 7. If the hydraulic control valve diaphragm or o-ring is damaged, please loosen the nut on the shaft core, break down the diaphragm or ring by Zhejiang, and replace it with a new diaphragm or o-ring . 8. A detailed examination of the main valve internal hydraulic control valve seat, shaft and other damage if any other debris in the main valve to clean it out. 9. In reverse order is the replacement of the main components of the valve assembly, pay attention to the phenomenon of the valve can not be jammed. Small Coil Galvanized Iron Wire Small Coil Galvanized Iron Wire Small Coil Galvanized Iron Wire,Big Coil Galvanized Iron Wire,Zinc Coated Iron Wire,Electro Galvanized Iron Wire Dingzhou Hongye Wire And Metal Products Co., Ltd. , http://www.chinawiremetals.com Like it? Share it! More by this author |