How to choose a coil nail

Posted by yy on February 18th, 2020

The nail rod of coil nail handles cent smooth rod, thread, ring grain and so on, smooth rod is easy to disassemble, thread is suitable for hardwood connection, ring grain is suitable for cork connection.

The surface treatment of coil nail is divided into dip paint, galvanizing, color zinc plating, dacromet, etc., generally only dip paint in China, dip paint uniformity on lubrication, fastening, antirust effect has a direct impact.

The nail head of the coil nail is pointed, blunt, chisel tip, blunt chisel, etc., according to the hardness and toughness of the material to decide, the domestic general only tip. Most users think that the more pointed the better, this concept is wrong, any nail has its special occasions, should be determined according to the specific situation, this and nail gun, materials have a certain relationship;

The nail gun and the nail coil have a good match, the nail gun design has certain requirements on the Angle of the nail coil, nail spacing, etc., the big nail has a good compatibility, for the following 2.3 wire diameter nail must be clear whether the nail gun and nail match.

The welding wire of coil nail is very important, good welding wire hardness and toughness is just right, the appearance of welding spot is neat, poor welding wire is easy to deform, easy to break in use, cause card nail.

Choose coil nail must be careful, spot welding distance is not standard nail will seriously affect the nail gun life and work efficiency; In addition, must pay attention to purchase the trap, in order to reduce cost, a lot of nail manufacturers to cut corners, wire diameter do fine, nails short, finally the latter was consumer, buying the nail, must use vernier caliper, said to, according to the size of the nail, weight and the label on the outer packing should be consistent, however the cheaper than buy a smaller size of nails.