How to operate the glass double edging machine?

Posted by sere on March 7th, 2020

Some often concerned about the glass industry friends may often hear people refer to the glass double edging machine, we often come into contact with various glass machinery in daily life, but how to operate the glass double edging machine, operating glass double edging machine grinding head need to adjust?

Operation steps of glass double edging machine:

1. wear good gloves, protective glasses and other labor protection supplies.

2. Adjust the grinding amount, thickness and width of the coarse fine wheel according to the glass to be processed.

3. Close the power switch (open the key switch)

4. Press the pump button to observe whether the pump starts and whether the cooling water nozzle position is suitable.

5. Press the button of grinding head motor to observe whether the grinding head motor starts, whether the working motor is normal and whether the steering conforms to the regulations.

6. Turn the transmission knob to feed direction and adjust the air pressure valve to 0.2-0.22.

7. Place the glass to be processed on the supporting wheel of the feeding rack and push it into the feeding rack. Between the wheels, the feed is transmitted synchronously into the upper and lower feeding section.

Adjustment method of grinding head of glass double edging machine:

1. Adjust the width and thickness of the glass; Turn on the grinding head motor, and be sure to wait 2 minutes for idling operation.

2. Pay attention when grinding: observe the operation of the whole machine, and if abnormal conditions are found, stop the machine immediately (press the main stop button), exit the glass and remove the trouble before starting the machine.

3. For appearance, size and other matters, the first piece shall be qualified before mass production.

4. Only 0.1mm can enter the grinding wheel when adjusting the coarse and fine grinding wheel of the machine, and it cannot be adjusted in place at one time.

5. If the glass to be ground has entered the upper and lower clipping section, it is found that the glass dislocation or fracture phenomenon cannot be directly plucked by hand (stop the machine and raise the upper conveyor belt to remove the glass or smash both sides of the glass with a hammer to avoid collision).

6. each class at the end of the processing, turn off after grinding head motor closed transmission, closed cooling water machine should be cleaned timely washed off the conveyor belt and guide front-rear wheel and other components on the broken glass, and clean water tank, water tank water suction mouth, in case of clear glass powder for a long time not sediment jam cooling water system. Use dry cloth to wipe off the machine appearance.

7. Lubricating (stator oil) shall be added to the oil cylinder at least once a week, and manual pressure pump shall be used to transfer oil to the mechanical tubing system. The linear guide rail and ball screw shall be thoroughly lubricated, and the width shall be adjusted from small width to large width for lot-off lubrication, so as to prevent the memory damage of guide rail and lead screw caused by grinding small glass for a long time.

8. transmission belt lubrication, please use light oil spray a little under the belt: less frequently.

9. Lubricate the motor slide seat once a week.