Maintenance of Garage Door

Posted by Secure for Sure on September 18th, 2021

Thorough examination and overhaul of your garage door are the best ways to ensure that we achieve the most extended life of your garage door. With periodic maintenance or too much wear and tear, garage doors can lock, stick, or even fall on people or cars and cause severe damage.

Accidents like these can also occur when we are performing maintenance on the garage door.

There are four primary points to keep in mind when working on our garage door:

It permanently unlocks the door opening and deactivates any control so that the door cannot be activated.

Attach pressure pliers to the roller tracks below the roller every time you work on an open door. Make sure all tension is removed from the door spring when you need to remove the lift cables. These pieces of metal can swing violently and cause severe lacerations if improperly released. Leave torsion springs up alone. Always call in a professional when working on this door piece.

Keep these tips in mind when you start to examine your garage door and review the best maintenance list out there for garage doors.

Tips for Proper Maintenance

Here are the tips for the garage door maintenance:

Test the balance of the garage door

If the garage door is not balanced perfectly, the garage door opener will have to work better, and it will not last as long.

After disengaging the opener by stretching the release handle, you must manually move the door over the middle of the door. If not maintained, the counterweight system (springs) is improperly balanced. The garage door spring adjustment is best left to the professionals.

Inspect and replace rollers

If they are worn, chipped, or cracked, you should replace the rollers as soon as possible. This is done by taking off and reinstalling the roller brackets that are not directly connected to the cable system.

Replace the weather-strip

It is the strip of cloth filled with tow or cotton or rubber placed on the edge of the doors and windows so that when closing, there are no gaps through which air or noise can enter or exit.

If the rubber sealing strip on the bottom of the door is brittle or cracked, replace it immediately to keep items out of the house. Weather-stripping is sold at hardware stores. Cut it to size and insert it into the slots with the wide-angle of the flange inside the door.

Check the cables

The power lines that lift your door should never be played with because they have enough force to maim and kill. However, you can check its status to know when to hire a professional. Check for broken threads and damage near the lower roller bracket.

Test anti-pinch safety features

There are two mechanisms: mechanical and photocell. To test the automatic function, place a piece of wood or brick on the ground in the path of the door. When the door comes down and touches that object, it should go back up again. To test the second, the photoelectric framework radiates on each side, close the entryway, and you need to pass your leg in the way of the entryway. Your entrance ought to be turned around.

If the opener is too old, it may lack basic fundamental safety features, and therefore, the time has arrived to purchase a new garage door opener.

Clean the tracks

Make sure the tracks on both sides of the door are clear of debris and, if you are leaning, you can use a level to check the plumb line. An expert garage door technician should make any significant track adjustments.

Garage Door Installation Lawnside | Garage Door Replacement Pennsauken | Garage Door Maintenance Coopersburg

Remember, the garage door makes up about a third of the house\'s exterior, so garage door maintenance is needed from time-to-time.

Like it? Share it!

Secure for Sure

About the Author

Secure for Sure
Joined: August 11th, 2020
Articles Posted: 87

More by this author