How to strip Concrete Paint

Posted by EaglePaintUAE on January 23rd, 2020

In this section, different ways to remove dried paint from the concrete surface will be addressed. You should be careful during the test, because a few times before you can completely clear the color, you may have to repeat them.

The technique #1: using paint stripers

The most common method to extract the paint from concrete requires the use of chemical stripers. This is the only way to achieve it. These can be used on all kinds of colors, including marine paints. On the market there are a range of different stripping agents available. Soja-based strippers are considered safe and convenient to use. It is found in gel form. Use the spray on the paint and let it sit for a while. This will release the stiff, dry paint to a certain degree. Then remove the gel with your paint from the concrete surface with a thick plastic scraper.

If the paint is dense, it will be necessary to apply more than one product. The best part of the chemical stripper is that the same adhesive strip can be used over and over on the stain. Brush the spot with a nylon brush after adding some scoring powder and water to remove soft paint traces after having removed the maximum number of paint from the cement. Eventually, absolutely rinse the area with plain water and return a free concrete paint sheet.

Stop the use in existence of toxic chemical strippers. They are strong but harmful to the eyes, skin and surroundings. Taking all possible care if you want to use them on a few stubborn paint stains. Any heater, kettle or pilot light stored in the area should also be turned off and properly air-conditioned.

The technique #2: The use of Shot Blaster

Shot blasting devices can easily be used to remove robust concrete paint. This computer is very pricey, and you can rent it from nearby homeshops. The operating principle of the sandblaster is quite similar. Instead of sand, it throws away miniscule metal beads. The abrasive material that is pushed out to the affected concrete surface under high pressure helps remove the color. It is fitted with a vacuum cap, which then purifies particles, pollutants and waste by aspiration. The unit should be transferred to the concrete so quickly that no concrete is lost. Shot blowing frequently causes significant damage to the concrete surface. Therefore, only if paint spots are poor should be used. With concrete already broken or chipped it isn't recommended, as its damaging effect can be so extreme that you have to patch the concrete immediately.

Find out more info on http://www.eaglepaintuae.com/